nspirephotocheck
Member
The one I keep seeing on pre-inspection walks: the water heater works fine, the temperature is right, and the unit still fails on the discharge pipe from the temperature-and-pressure relief valve.
What actually solves it is boring and cheap. The pipe has to run down close to the floor, end where you can see it, and not be capped, threaded at the end, or routed uphill into a drain where a leak would hide. A pipe that stops short, or one that disappears into a wall, reads as a scald and flooding risk — and it is one.
Before your next inspection, walk every water heater and look at that pipe the way an inspector will: where does it end, and could anyone see water coming out of it?
What is the strangest TPR setup you have found in a unit?
What actually solves it is boring and cheap. The pipe has to run down close to the floor, end where you can see it, and not be capped, threaded at the end, or routed uphill into a drain where a leak would hide. A pipe that stops short, or one that disappears into a wall, reads as a scald and flooding risk — and it is one.
Before your next inspection, walk every water heater and look at that pipe the way an inspector will: where does it end, and could anyone see water coming out of it?
What is the strangest TPR setup you have found in a unit?